Delays to international delivery are still happening, especially to the USA. Please allow 4 weeks and get in touch if your parcel has not arrived. Thanks : )
Delays to international delivery are still happening, especially to the USA. Please allow 4 weeks and get in touch if your parcel has not arrived. Thanks : )
Cart 0

Building the 1/24th scale Toilet Brush

1/24th scale Instructions

Here's a quick run through of how to put this model together. You will need:

  • snips or side cutters
  • acrylic paints
  • gentle sandpaper (400 or 800 grit)
  • superglue
  1. Use snips or side cutters to remove the long support piece before painting, here and here:
  2. Paint the pieces separately.
  3. Remove supports from each piece.
  4. Lightly sand underneath the main body part so it's nice and flat.
  5. Put a tiny bit of superglue on the sanded edge.
  6. Put it down onto the base part, adjust the fit if needed.
  7. The handle and brush fit loosely inside. Finished!

I hope this was helpful! If you'd like to buy this kit, or a finished and painted piece, they are available on my shop here. There's also a (non-opening) 1/48th scale version which you can see here.


Older Post Newer Post


Leave a comment

Please note, comments must be approved before they are published